Skip to content

Country

PIER CITY CYCLES TUTORIAL - BMW R9T Charcoal Canister Removal

PIER CITY CYCLES TUTORIAL - BMW R9T Charcoal Canister Removal

In this tutorial, we'll show you how to remove the charcoal canister on the EU4 models of BMW R9T. This is a modification that allows you to tidy up the back end of the bike and requires minimal spend and only 15 minutes of your time in the garage. There are no fault codes or running issues when carrying out this mod.

Parts details below. Parts Required; BMW Protection Cap; 1 x 13 54 7 694 924 Tools Required; A Ratchet A T25 Torx Bit A T30 Torx Bit A small flat bladed screwdriver

Older Post
Newer Post

Leave a comment

Please note, comments must be approved before they are published

Blog posts

Remapping & Fuelling Modules Explained

Horses losing their way? There's a map for that. If you're modding your bike's exhaust or air systems (or even if you're not, on a Gen.3 bike) then you should read this article.

The Bike Shed 2024

A week on from unloading at Tobacco Docks, everything is back in the workshop and the dust is just about settling. Th...

Unveiled: The New R12 and R12 NineT

This evening, BMW unveiled their new, fourth generation R9T – and this time round the bike has had a much larger over...
Back to top

Added to cart